RING SIZE

 

Ideally fingers should be sized properly by a profesional jeweller using a ring sizer.  If this is not possible then the following may be used to estimate your size.

​

How to measure Ring size

​

Follow these directions to measure your finger. They will give an approximate guide to establish your ring size. For a completely accurate measurement go to a jeweller and have your finger sized precisely.

​

Select a ring you own that properly fits the intended finger.

​

1 - Measure the inside DIAMETER of the ring in millimeters (mm).

​

2 - Wrap a strip of paper around your finger, Mark the point where the two ends meet, Measure the paper against a ruler in millimeters (mm) to get the CIRCUMFERENCE of your finger.

​

Match the measurements to the conversion chart below.

 

More Tips to Ring Size

​

 1 - Your finger size can change throughout the day, so it is a good idea to measure at the end of the day when your fingers are at their largest. Do not measure when your hands are cold; your fingers will be at least half a size smaller.

​

 2- Rings with a particularly thick band will feel tighter than a thin band; in these cases, we recommend buying a full size larger than your normal ring size.

​

 3 - Your ring should fit your finger comfortably; it should of course be snug enough so that it will not fall off, but loose enough to slide over your knuckle.

​​

​When ordering rings online it is the buyer’s responsibility to ensure they have ordered the correct size. If the ring is suitable for re-sizing, we will happily re-size but please note that a charge may occur.

​

​